一种新型温度自补偿高灵敏度折射率计

基于高频CO2激光脉冲写入的新型超长周期光纤光栅(ULPFG),提出了一种可实现温度自补偿的新型高灵敏度折射率计。理论与实验表明,新型超长周期光纤光栅不同闪耀阶次谐振峰对外界折射率与温度变化的灵敏度各自不同,特别的是,该光栅存在对外界折变不敏感的谐振峰,测量中除了可以利用该峰实现温度同时测量外,还可以补偿另一个测量折变的谐振峰因温度变化带来的测量误差。该折射率计具有制作简单、成本低、强度好,灵敏度高等优点,当外界折射率在1.43~1.45范围内变化时,其折射率测量灵敏度可达每单位折射率240 nm,在实际工业应用中具有较大的潜在实用价值。     

5 TW/40 fs级台式钛宝石激光系统研究

在TSA-25系统输出35 mJ,800 nm啁啾脉冲的基础上,建立了以钛宝石作为增益介质的二级啁啾脉冲放大(CPA)系统。使用0.6 J和1.6 J,532 nm,10 Hz Nd∶YAG激光抽运,输出脉冲能量达到500 mJ,经压缩脉冲宽度为41 fs,压缩器的能量转换效率为63%,峰值功率可达7.6 TW。通过对放大器系统的钛宝石晶体、抽运密度以及多通结构通道数的选择等实验,有效地提高了能量放大器的萃取效率。其主放大器能量萃取效率达到32%,整个系统占用尺寸不到10 m2。     

聚甲基丙烯酸甲酯掺杂Ce3+的飞秒激光三维信息存储

用飞秒激光(200 fs,1 kHz,800 nm)脉冲在掺杂稀土离子Ce3 的聚甲基丙烯酸甲酯(PMMA)膜中进行了光存储实验研究,包括对样品的吸收光谱、激光照射前后的电子旋转共振(Electron spin resonance,ESR)光谱的测量和讨论。结果表明掺杂稀土离子Ce3 的聚甲基丙烯酸甲酯膜具有较低的写入阈值,有利于高速、并行的三维光存储。实验结果采用传统光学显微镜并行读出。给出了四层存储结果(点间距和层间距分别是4μm和16μm),并讨论了脉冲能量的大小对空腔尺寸的影响,进行高密度存储时,在保证读出信号灰度值足够大的情况下,应选择尽量小的激光脉冲写入能量。实验结果表明这种材料可以应用于三维光信息存储。     

Differential Pulse Polarographic Determination of Nitrate in AUT Solution

A differential pulse polarographic method for the determination of nitrate ion has been developed. With 0.5 M CaCl₂ as supporting electrolyte, NO^?₃ is reduced to give a peak with E_1/2=–1.836 Volt vs. the Ag/AgCl electrode. The differential pulse polarographic peak height is proportional to the nitrate concentration from 20 to 60 ppm. The detection limit for nitrate is 2 ppm in pure aqueous solution. In the determination of 40 ppm nitrate a relative precision (relative standard deviation) of less than 2% was achieved. Nitrite interferes seriously and should be absent if accurate results are required. The method has been applied to the determination of nitrate in Ammonium Uranyl Tricarbonate (AUT) Solution, results obtained by this method are compared to those obtained by ion chromatography. The agreement between the two sets of results suggests that the DPP method can be used with a fair degree of confidence.     

脉冲离散效应对光纤中基于交叉相位调制的脉冲压缩的影响

通过数值模拟，分析了脉冲离散效应对单模光纤正群速色区基于暗孤子交叉不相位调制的脉冲压缩的影响，并提出了减轻这种影响的办法，作者发现，即使暗孤子与被压缩脉冲的中心波长相差很小，离散效应对脉冲压缩的影响也很大，离散效应不仅导致脉冲压缩比的减小和压缩后脉冲峰值功率的降低，而且还导致脉冲压缩所需最佳光纤长度的增加以及压缩后的脉冲呈现不对称性，还发现，若采取本文提出了的非同步耦合法，则可以明显地弥补离散效应     

单个波长到多个波长的变换实验

报道一种波长变换的新方法.采用此方法不需要任何泵浦光便能够直接将信号光变换成在特定谱宽内的任意多个任意波长的变换光,这对于将来的波分复用光网络提供了较大的方便.此波长变换的原理是利用色散位移光纤的非线性效应产生超连续光谱(SC)信号,由于这种SC信号携带有变换光信号,对这种连续谱进行滤波便能够得到所需要的任意频率的变换信号.此变换方式具有变换频带宽,偏振不敏感的优点。     

氨基乙硫醇修饰金电极直接测定芦丁含量的研究

利用分子自组装技术制备氨基乙硫醇修饰金电极,并采用脉冲伏安法直接测定芦丁的含量。以pH7.0的乙醇和磷酸盐混合缓冲溶液作底液,芦丁在氨基乙硫醇修饰金电极上于0.19 V(vs.SCE)处呈现一灵敏的氧化电流峰,峰电流和芦丁的浓度在8.0~2.5×102μmol/L范围内呈良好的线性关系。由于抗坏血酸在氨基乙硫醇修饰金电极上的氧化电位出现显著负移,因此,可避免抗坏血酸对芦丁检测的干扰。本方法可以不经预分离直接检测药物中芦丁含量。     

Anodic Stripping Voltammetry of Heavy Metals at Nanocrystalline Boron‐Doped Diamond Electrode

Boron‐doped Diamond (BDD) electrode has become one of the important tools for heavy metal detection. By studying some analytical parameters of DPASV method, like deposition time and potential in different electrolyte concentrations (acetate buffer), the conditions for detecting very low metal ion levels (Zn, Cd, Pb, and Cu) could be chosen. Diluted electrolyte (0.01 M buffer) was one of the factors favoring low detection and quantification limits, but its quantification range is short in comparison to more concentrated media. For ?1.7 V deposition potential, the detection of single metal at ppb levels was reached in 60 s deposition time. Understanding different metal‐metal interactions shows the limits to the simultaneous determination of heavy metals at BDD. Quantification was possible for the simultaneous determination of Zn, Cd and Pb despite the overlapping of Zn and Cd peaks. The performance of the BDD was compared with that of another C‐based solid electrode: the glassy carbon electrode (without mercury plating). A lower base line current, wider potential range, higher sensitivity (3 to 5 times higher than GC) and longevity of the material were noticed for the BDD.     

5-羟色胺在碳纤维微电极上的电化学测定及伏安行为研究

本文研究了5 羟色胺在Na2HPO4 KH2PO4(pH6.0)缓冲溶液中,于自制的碳纤维微电极上的伏安行为。在此缓冲溶液中5 羟色胺有一对氧化还原峰,峰电位分别为0.2V和0.4V。峰电流与5 羟色胺的浓度分别在4.0×10-6～4.0×10-5mol/L和5.0×10-6～5.0×10-5mol/L范围内呈良好的线性关系,检出限分别为4.70×10-6mol/L和1.76×10-6mol/L。同时利用多种电化学方法求出了动力学参数。     

植物生物分子的电分析化学研究——Ⅸ.多酚氧化酶活性的脉冲极谱法测定

本文用微分脉冲极谱法研究了多酚氧化酶的活性测定和酶的反应动力学。应用于马铃薯等10余种植物样品的酶活力测定,结果良好。方法简便快速,重现性好。